Cub Cadet SLTX1000 Series - Manual (Page 75)

HYDRO. DRIVE AND BRAKE SYSTEM
69
11. Allow the drive pedal shaft to rotate down, then pull it
off of the pedal shaft assembly. See Figure 5.28.
12. Disconnect the brake rod from the clutch/brake latch
plate. See Figure 5.29.
• Remove the cotter pin and flat washer to discon-
nect the brake rod. Discard the cotter pin.
• Unhook the brake rod from the clutch/brake latch
plate.
13. Remove the left side pedal shaft support strap, and
lower the pedal shaft assembly out of the tractor.
See Figure 5.30.
Figure 5.28
Drive control
pedal shaft
Figure 5.29
Brake rod
Flat washer
Clutch/brake
latch plate
Figure 5.30