Cub Cadet Z-Force S Series - Manual (Page 20)

Z-Force-S
14
Parking brake lever
To remove/replace the parking brake lever:
1. Remove the cutting deck by following the proce-
dures described in Chapter 8: Cutting Decks and
Lift shaft.
2. Move the parking brake lever to the “OFF” position.
3. Remove the extension spring that runs from the
brake lever to the brake shaft. See Figure 3.16.
NOTE: When the parking brake lever is in the “ON”
position, this spring pulls on the lever apply-
ing pressure to the parking brake switch.
4. Remove the two screws from the underside of the
left control panel using a T-30 torx driver.
See Figure 3.17.
5. Remove the grip from the parking brake lever.
See Figure 3.18.
6. Remove the two screws that hold the left control
panel to the seat box assembly using a T-30 torx
driver. See Figure 3.18.
7. Remove the two screws that hold the control panel
to the control pods using a T-30 torx driver.
Figure 3.16
Brake lever
Brake shaft
Spring
Figure 3.17
Left control panel
Figure 3.18
Screws
Grip