Cub Cadet Z-Force S Series - Manual (Page 66)

Z-Force-S
60
To assemble the steering gear box:
1. Put a dab of 737-0300A Durina TM grease into each
of the bushings in the lower housing.
See Figure 6.47.
2. Install both of the bevel gears with the rollers in-line
with the steering shaft. See Figure 6.48.
3. Install the washer on the steering shaft.
4. Place the thick washer over the splines on the sec-
tor gear. See Figure 6.49.
5. Place the thin washer on top of the thick washer.
6. Insert the sector gear into the internal cam.
NOTE: There is a master spline on the sector gear
and the internal cam to ensure correct tim-
ing. See Figure 6.49.
Figure 6.47
Put a dab of grease
in each bushing
Figure 6.48
Rollers in line with the
steering shaft
Figure 6.49
Master spline