Cub Cadet Z-Force S Series - Manual (Page 26)

Z-Force-S
20
6. Disconnect the engine harness from the main har-
ness. See Figure 4.8.
7. Disconnect the starter cable. See Figure 4.8.
8. Remove the grip from the parking brake lever.
See Figure 4.9.
9. Remove the two screws that hold the left control
panel to the seat box assembly using a T-30 torx
driver. See Figure 4.9.
10. Remove the two screws that hold the control panel
to the control consoles using a T-30 torx driver.
11. Carefully lift up on the control panel to gain access
to the wiring under it.
12. Disconnect the wiring harness from the switches
and modules. See Figure 4.10.
13. Lift the control panel off of the mower.
NOTE: If the control panel is being replaced,
remove the switches and modules from it
and install them on the new control panel.
Figure 4.8
Starter
cable
Engine harness
connector
Figure 4.9
Screws
Grip
Figure 4.10
Hour meter
PTO switch
RMC module
Key switch