FRITSCH PULVERISETTE 6 classic line - Manual (Page 41)

6.11.1 Overload
If the mill is overloaded, the speed is reduced and the REDUCED SPEED
light flashes.
The mill switches off if the overload continues for too long; see
Ä Chapter 10.1 ‘Checklist for troubleshooting’ on page 53.
6.11.2 Switching off
n Press STOP on the control panel.
n When the drive comes to a standstill, the hood is unlocked and can
be opened.
n If the device is not in operation for a long time, switch off the main
switch (10) on the back side.
6.12 Cooling the grinding bowl
WARNING!
Burn hazard!
Grinding bowls can get very hot after long grinding dura-
tions. Wear protective gloves for removal after grinding or
during the grinding breaks.
n When the hood is open (3), or
n In the programmed pause times with closed (locked) hood and the
fan running.
6.13 Stand-by
If the mill is not in operation and the hood (3) is open, it switches to the
energy-saving stand-by mode after one hour. The STAND-BY lamp lights.
The stand-by function is not possible when the hood is closed.
Using the device
- 41 -