FRITSCH PULVERISETTE 14 - Manual (Page 15)

1. Remove the mains plug and fully unscrew the connection plate
and filter unit on the back (7 screws).
2. Open the lock (b) with the triangular key (a) by turning it to the
right.
3. The housing cover can now be flipped open.
4. In order to be able to operate the PULVERISETTE 14 again, activate
the safety lock by turning the triangular key to the left and close
the housing cover.
Only when the lid is locked can the motor be started by
pressing the [START] key. After pressing the [STOP] key, an
electronic brake brings the motor to a halt within approx.
10 seconds.
The housing cover can only be opened after the cover lock
has been released by the motor's speed monitor.
2.7 Hazardous points
DANGER!
Mains voltage!
When opened, the device has protection class IP 20, i.e.
water and particles <12 mm can enter the device. Keep this
in mind when cleaning (Ä Chapter 7 ‘Cleaning’ on page 41)
and when removing the grinding elements (Ä Chapter 6.5
‘Removing the grinding elements’ on page 29).
Safety information and use
- 15 -