Jaclo Thermostatic Valve, Rough - J-TH34 - Manual (Page 13)

jaclo industries | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133 JACLO.COM | PG 13
CREATED 5.2014
| PG 13
(10) Dial Pointer, Trim and Handle Installation
A. Push the dial pointer on to sleeve with pointer on top at 12 o’clock position. See Fig. 7.
B. Turn on diverter valve to allow water to flow. Measure water temperature and adjust to 100°F.
C. Install dial assembly on to spindle aligning the 100° to the dial pointer. See Fig. 7
D. Place adhesive backed foam strip to back side of trim plate.
E. Slide trim plate over sleeve against finished wall.
F. Install handle to desired position using center screw or set screw, trims may vary.
(11) Valve Operation
A. Diverter/Volume control operation. See Fig. 6
i. Two way diverter is off at 12 o’clock position full on “A” port a 9 o’clock position, full on “C” port at
3 o’clock position. Water volume increases as control moves toward full on positions. Control moves
180 degrees through full use.
ii. Three way diverter is off in 2, 6, 10 o’clock positions. “C” port full on in 4 o’clock position. Control
moves 360 degrees clockwise or counter clockwise through full operation. Water volume increases as
control moves toward full on positions. Valve has detents in full on and stop positions.
B. Thermostatic valve operation. See Fig. 6
i. Temperature increases as control is moved counter clockwise.
ii. Use temperature dial as indicator.
Figure 7
DIAL POINTER
DIAL ASSEMBLY