Kistler-Morse KM LD360s - Manual (Page 11)

Chapter 2:
Preparing for the Load Disc Installation
Check Shipment
Check Load Disc Order Items
The following items are included with a typical order for each vessel
(quantities dependent on application):
Load Disc Load Cell
Junction Boxes or Molded Junction Boxes
Top or Bottom Hardware
If any items are needed, contact KM before proceeding. Substituting
parts without KM approval may cause system problems and will void
the warranty.
Visual Check
Visually inspect all equipment in the order — including Load Discs,
junction boxes, and signal processors — to verify they have not been
damaged during shipment. If any item has been damaged, contact KM
for a replacement.
This chapter describes the pre-check procedures for the Load Disc.
Checking the Load Discs before installation will ensure properly
working equipment that will provide accurate monitoring of vessel
contents.
Note:
A KM signal processor or a
KM Test Meter are required
to set up and install the
system.
Perform the following prior to installing the Load Disc:
Chapter 2: Preparing for the Load Disc Installation
2-1