Installation configuration, Introduction, Dedicated applications – Kofax INDICIUS 6.1 User Manual
Page 33
Installation
Installation Guide
23
Installation Configuration
Introduction
Installation configuration is an optional part of the installation process. It is required
only if modules are to be installed as Windows Services or set up to perform special
functions when opened as dedicated applications.
Installation configuration requires you to specify command line parameters.
Depending on how the modules are run, there are two ways to do this:
When any module is run as a dedicated application, the command line
parameters are specified on a shortcut.
When Recognition and Scripted Export are run as dedicated Windows
services, the command line parameters are specified at the command prompt
during installation of the Windows services.
The following sections describe how to use the command line parameters for the
Dedicated Applications
and then for the
Windows Services
.
Dedicated Applications
The command line parameters are specified for each application using a shortcut.
This section first describes how to edit a shortcut, then provides examples using the
different parameters.
Editing a Shortcut
To specify command line parameters on a shortcut
1
Create a shortcut to the application on a user’s desktop or Start menu.
2
Right click on the shortcut and select Properties to open the properties
window.
3
Select the Shortcut tab.
4
Move to the end of the text in the Target box and add a space after the
current text.
5
Add the command line parameters as described in the following examples
6
Click OK.
The names of the applications are: