Kofax INDICIUS 6.1 - Manual (Page 34)

Chapter 4
24 Installation Guide
Table 3-3. Application File Names
Module Application Name
Recognition ka_iform.exe
Document Review ka_document review.exe
Correction ka_correct.exe
Completion ka_kfi.exe
Verification ka_verify.exe
Scripted Export ka_scriptex.exe
Command Line Parameters
Note The INDICIUS Help lists the full set of command line parameters which you
can use to modify the start-up behavior of the INDICIUS modules. None of these
parameters are mandatory.
To specify a Kofax Capture User Profile username and password
1 In the properties window for the shortcut enter the –u parameter followed by
the username, then the –p parameter followed by the password:
<application filename> -u <username> -p <password>
For example, to configure Recognition to automatically log into Kofax
Capture using a specific user profile:
ka_iform.exe –u recognitionuser –p recognitionpassword
2 Click OK.
Note These options can be used to automatically log on to Kofax Capture when the
module is started, and are often used in conjunction with –autostart when User
Profiles are enabled.
Both options must be specified and both are case-sensitive.
To automatically start processing batches when the application starts
1 In the properties window for the shortcut enter the –autostart parameter: