Chicago Electric Power Tools 7" Angle grinder 67648 - Manual (Page 13)

Page 13 For technical questions, please call 1-800-444-3353. SKU 67648
Assembly
installing the wheel guard
tO preVent
SeriOuS injurY:
do not operate this tool without
the wheel guard properly
installed.
Using the Hex Wrench (55), 1.
Figure 2
1
2
3
Socket Head
Bolt (4)
Gear Housing Rim
Hex Wrench
(55)
Wheel Guard (3)
loosen the
Socket Head Bolt (4) and slide the collar
of the Wheel Guard (3) over the rim of
the Gear Housing.
Rotate the Wheel Guard as needed to
2.
shield you during the planned work.
Use the Hex Wrench (55) to tighten
3.
the Socket Head Bolt securely. Check
the Wheel Guard to ensure it is firmly
in place. Adjust if necessary before
proceeding.
installing the Auxiliary handle
tO preVent
SeriOuS injurY:
do not operate this tool with one
hand only or without the
Auxiliary handle properly
installed.
Figure 2
Auxiliary Handle locations
1. The Auxiliary Handle (23) may be
installed in one of three positions,
on either side or on top of the Gear
Housing.
Screw the threaded end of the Auxiliary
2.
Handle into the selected position.
Tighten securely before beginning work.