Chicago Electric Power Tools 7" Angle grinder 67648 - Manual (Page 16)

Page 16 For technical questions, please call 1-800-444-3353. SKU 67648
MAintenAnce And
SerVicing
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
tO preVent
SeriOuS injurY
FrOM AccidentAl
OperAtiOn:
turn the power Switch of the tool
off and unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
tO preVent SeriOuS injurY
FrOM tOOl FAilure:
do not use damaged equipment.
if abnormal noise or vibration
occurs, have the problem
corrected before further use.
cleaning, Maintenance, and
lubrication
beFOre eAch uSe, 1. inspect the
general condition of the tool. Check for
loose screws, misalignment or binding of
moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
Periodically blow dust and grit out of
2.
the motor vents using dry compressed
air. Always wear ANSI-approved safety
goggles and NIOSH-approved breathing
protection when performing this
maintenance operation.
AFter uSe,
3. wipe external surfaces
of the tool with a clean cloth. Do not
use solvents or harsh cleaners as they
may damage the housing. To prevent
electrical shock, do not allow water or
other liquids to enter the motor vent
holes.
The grease in the gearbox will require
4.
replacement after extensive use of the
grinder. Have the tool serviced by a
qualified technician for this procedure.
5. wArning! if the supply cord of
this power tool is damaged, it must be
replaced only by a qualified service
technician.