Casio TC-540 - Manual (Page 25)

18 18 18 18 18
PAGE
AUTODIAL
TIME PAGE MEMO/CONV
3 1
DEF
2
ABC
LINE IN USE
CHARGING
STORE OUTGOING MESSAGE
CHECK RECORD
STORING AUTODIAL
NUMBERS
You may store up to 10 of your most frequently
dialed numbers in autodial memory. Autodial
station numbers can be up to 16 digits each. To
store autodial numbers, the AC ADAPTER must
be connected correctly. Numbers may only be
stored at the base unit.
1
AUTODIAL
BASE
Press STORE (under the lid in the
handset cradle).
Press a keypad number (0-9) as the
autodial location for that number.
4
2 Enter one of the telephone numbers you
want to store in the autodial memory by
dialing it on the keypad. You will hear a
confirmation tone after entering each digit.
3
Press AUTODIAL .
AUTODIAL
STORE
1
5
Press STORE .
NOTES:
To relocate your TC-540, unplug the AC ADAPTER from the
wall outlet and install the unit at a new location. If a 9 volt
battery is installed, the autodial memory, message count, and
time/day stamp will be saved for 1 hour during a power failure.
You can store important emergency numbers in autodial
memory (police, fire, medical 911 for example) but Casio
Phonemate assumes no responsibility for this feature. When
programming and/or making test calls to emergency numbers,
remain on the line and briefly explain to the dispatcher the
reason for the call. Perform such activities in off peak hours,
such as early morning or late evenings.
6
Repeat steps 1-5 to store up to 10
autodial numbers.
7
To exit the programming mode any time
during programming, press
STORE or
wait 10 seconds. You will hear a double
beep when the TC-540 exits the
programming mode.
8 Write the names and telephone numbers
of the people whose numbers you have
stored on the TC-540’s autodial index
(located in the handset cradle.)