A&D Weighing FC-500Si - Manual (Page 39)

‰ Display ON Unit Weight – Reset or Last.
When the display is turned on, the scale can be set to recall
the last unit weight used.
0
3 The unit weight is RESET (cleared) when display comes on.
1
The unit weight last used (before display is turned off, not
power interrupt) will be entered automatically.
‰ ID Memory Contents.
The scale ID memory can contain unit weights with tare
weights, comparator limits and total count, or just unit
weights alone. Item codes are always contained.
000
3 ID memory contains the unit weight and item code only.
You select which data to be stored by keying in a
0 or 1 for the data: tare weight, comparator
limits or total count.
Example: Key in 0 1 0 to display 010, ID
memory contains the unit weight including item
code and comparator limits.
‰ Unit Weight With A 2 Scale System.
When operating a 2 scale system, the remote scale may
have an independent unit weight, or restricted to the same as
the main scale.
0
Each scale can have its own unit weight.
1
3 Main and remote scales have the same unit weight only.
f-01-04
f-01-06
F-01-06 requires
OP-05 and a
remote scale
f-01-05
000
Comparator
limits
TOTAL TARE
count Weight
37