Cisco 545 Serial - Manual (Page 21)

C H A P T E R
2-1
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5
OL-14912-01
2
Installing the Cisco Unified
Videoconferencing 3545 Gateway
This section describes the following topics:
• Physical Description, page 2-1
• Preparing for Installation, page 2-3
• Verifying the Package Contents, page 2-4
• Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack, page 2-5
• Installing the Gateway, page 2-6
• Initial Gateway Configuration, page 2-10
• Connecting the Gateway to the Network, page 2-14
• Connecting PRI Lines to the Gateway, page 2-14
• Connecting Serial Lines to the Gateway, page 2-14
• Serial Gateway Cable Connections and Pin-outs, page 2-15
• Connecting the Gateway to a Power Source, page 2-27
• Accessing the Gateway Administrator Interface, page 2-27
• Registering the Online Help, page 2-28
Physical Description
This section provides a physical description of the gateway modules and their corresponding RTMs.
Gateway Module
The gateway module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector
to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a
hyperterminal program to configure and monitor the module.
Figure 2-1 shows the front panel components of the gateway module. Table 2-1 describes these
components.