Bmw x5: bulb replacement – BMW 2013 X5 User Manual

Page 289

Advertising
background image

The manufacturer of the vehicle recommends
that you entrust corresponding procedures to
the service center if you are unfamiliar with them
or they are not described here.
You can obtain a selection of replacement bulbs
at the service center.

Danger of burns
Only change bulbs when they are cool;

otherwise, there is the danger of getting
burned.◀

Working on the lighting system
When working on the lighting system, you

should always switch off the lights affected to
prevent short circuits.
To avoid possible injury or equipment damage
when replacing bulbs, observe any instructions
provided by the bulb manufacturer.◀

Do not perform work/bulb replacement on
xenon headlamps

Have any work on the xenon lighting system, in‐
cluding bulb replacement, performed only by a
service center.
Due to the high voltage present in the system,
there is the danger of fatal injuries if work is car‐
ried out improperly.◀

Wear protective goggles and gloves
Halogen bulbs are pressurized. Therefore,

wear protective goggles and gloves. Otherwise,
there is a danger of injuries if the bulb is acci‐
dentally damaged during replacement.◀

Do not touch the bulbs
Do not touch the glass of new bulbs with

your bare hands, as even minute amounts of
contamination will burn into the bulb's surface
and reduce its service life.
Use a clean tissue, cloth or something similar, or
hold the bulb by its base.◀

Light-emitting diodes LED

Light-emitting diodes installed behind translu‐
cent lenses serve as the light source for many of
the controls, displays and other equipment in
your vehicle.
These light-emitting diodes, which operate us‐
ing a concept similar to that applied in conven‐
tional lasers, are officially designated as Class 1
light-emitting diodes.

Do not remove the covers
Do not remove the covers, and never stare

into the unfiltered light for several hours; other‐
wise, irritation of the retina could result.◀

Headlamp glass

Condensation can form on the inside of the
headlamps in cool or humid weather. When you
drive with the lights switched on, the conden‐
sation evaporates after a short time. The head‐
lamps do not need to be changed.
If the condensation in the headlamps does not
evaporate after trips with the lights switched on,
and the amount of moisture in the headlamps
increases, for example if water droplets form,
have them checked by your service center.

BMW X5: bulb replacement

Xenon headlamps

Notes

Because of the long life of these bulbs, the like‐
lihood of failure is very low. Switching the lamps
on and off frequently shortens their life.
If a xenon bulb fails, switch on the front fog lamps
and continue the trip with great care. Comply
with local regulations.

Do not perform work/bulb replacement on
xenon headlamps

Have any work on the xenon lighting system, in‐
cluding bulb replacement, performed only by a
service center.

Seite 289

Replacing components

Mobility

289

Online Edition for Part no. 01 40 2 901 869 - 03 12 500

Advertising