Whirlpool FEP350Y - Manual (Page 22)

C A R I N G F O R Y O U R R A N G E
Replacing
1.
Maks sura
all surface units are off and
cool before replacing surface units and
reflector bowls.
2.
Line up
openings in the reflector bowl
with the surface unit receptacle and the
element hold-down clip.
3. Hold
the surface unit as level as possible
with the terminal just started into the
receptacle.
Push
the surface unit terminal
into the receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, push
down
the edge of the surface unit
opposite the receptacle. The element
hold-down clip will keep the surface unit
from moving arourKf.
NOTE: Reflector bowls reflect heat back to
the utensils on the surface units. They also
help catch spills. When they are kept clean,
they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of
your utensils may not be flat enough, or
some may be too large for the surface unit.
In either case, some of the heat that’s meant
to go into or around a utensil goes down arxi
heats the reflector bowl. This extra heat can
discolor it.
22