Whirlpool FGP335B - Manual (Page 19)

C A R I N G F O R Y O U R R A N G E
2. Hold the door at the sides near the top.
Insert hinge arms into slots at the bottom
of the door. Insert arms evenly, as far as
they will go.
3. If the door is not in line with the oven
frame, remove it and repeat the above
steps.
4. Replace the screws on the oven door.
Hinge arm
Removing the oven bottom
The panel in the oven bottom can be
removed for cleaning.
^WARNING
Burn Hazard
Make sure all parts are cool before
removing.
Failure to do so could result in burns.
To remove:
1. Remove oven racks.
2. Remove the two hold-down screws at the
rear of the oven. If screws are too tight to
remove by hand,
use a screwdriver.
3. Place fingers in slots in bottom panel and
lift rear of panel up and back until lip at
the front of panel is clear of front frame of
oven cavity.
4. Lift bottom up and out.
To replace:
1. Place oven bottom panel in oven with the
back raised about 6 inches or until you
can insert the hold-down lip at front of
panel under the front frame of oven
cavity.
2. Push back of oven bottom panel down
fully into place on metal flanges on rear
wall and
insert the hold-down screws. 19