Canon 800 - Manual (Page 19)

– 17 –
Connecting to a Computer
To use the Microfilm Scanner 800 in Scanner mode, you
will need the following equipment in addition to the
accessories provided with the scanner:
• Computer
• SCSI card
• SCSI cable
IMPORTANT
No SCSI cable is supplied with the scanner. To
connect the scanner to a computer, obtain a SCSI
cable with the correct connectors for the scanner and
the SCSI card installed in the computer. The SCSI
connector on the scanner is a half-pitch 50-pin
connector (pin-type).
Connecting the Computer
Connection of the SCSI cable to the main unit and the
specification of the SCSI ID and other settings should be
done by the supervising service personnel. To change the
SCSI ID or any other connection settings, contact the
service person.
Note
At shipment, the SCSI ID for the scanner is set to 2
and the terminator setting is OFF.
Device Drivers
If the computer is running the Windows 95/98, a screen
requesting installation of the scanner driver (“New Hard-
ware” or “Device Driver Wizard”) will appear the first
time you switch the computer on after connecting the
scanner to the computer. In the “New Hardware” screen,
choose “Select from list” and click “OK”. In the next
screen, select “Other devices” and click “OK”.
In the “Device Driver Wizard” screen, click “Next” and
then click “Completed” in the next screen.