Canon 800 - Manual (Page 22)

– 20 –
Switching On
Use the procedure below to switch the scanner on.
IMPORTANT
If an FS Controller III is installed on the scanner,
switch the FS Controller III on first.
1 Press the “|” side of the power switch to turn on the
main unit. When the main unit is switched on, the Start
key glows red and the scanner switches.
(In ReaderPrinter mode: Green. In Scanner mode: Red)
2 Switch on the computer and printer.
IMPORTANT
Switch on any SCSI devices connected to the com-
puter before you switch on the computer.
Switching Off
1 Switch off the computer and printer.
2 Press the “o” side of the power switch to switch the
scanner off.
IMPORTANT
If the scanner will not be used for a lengthy period,
unplug the power cord as a safety measure.
Loading the Film
Because film loading methods differ for each carrier, refer
to the instructions provided with the carrier for information
on how to load the film.
Using the Scanner
Using the Scanner