Cisco 7200 VXR - Manual (Page 10)

10
3
Rack-Mount the Router
Figure 4 Attaching the Rack-Mount Brackets to the Front of the Chassis
Brackets Front-Mounted—Chassis Protrudes from the Rack
Locate the rack-mount and cable-management brackets and screws and a Number 2 Phillips screwdriver.
Step 1 Align the rack-mount bracket (1)—as shown above—to the side of the router. Insert and tighten the screws (3) if you
are not adding the cable-management brackets. Repeat this step on the other side of the router.
Go to the “Two-Post or Four-Post Rack Installation” section on page 16.
Step 2 If you are using the cable-management brackets, align the rack-mount bracket (1) to the side of the router, align the
cable-management bracket (2) over the rack-mount bracket—as shown above—and insert the screws (3) through both.
Tighten the screws. Repeat this step on the other side of the router.
If you have an NPE-G1 or NPE-G2 installed, go to the “NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a
Front-Mounted Router” section on page 12.
If you do not have an NPE-G1 or NPE-G2 installed, go to the “Two-Post or Four-Post Rack Installation” section on page 16.
1 Rack-mount bracket 3 M4 x 8-mm Phillips flathead screws
2 Cable-management bracket
53498
2
ETHERNET-10BFL EN RX 0 1 2 3 4 TX RX TX RX TX RX TX RX TX
ETHERNET 10BT
EN A B LE D
0 2
1 3 LIN K 0 1 2 3
0
4
1
3
5 6
FAST SERIAL EN TD TC R D R C LB C D TD TC R D R C LB C D TD TC R D R C LB C D TD TC R D R C LB C D
ENABLED M II L IN K R J4 5
FAST ETHERNET
0
TOKEN RING
0 1 2 3 EN ABLE D IN -R IN G
4/16 M
bp s
Cisco 7200
Series
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED PCMCIA EJECT SLOT 0
FE
ENABLEFE LINK CPU RESET 1O POWER OK
SLOT 1 FE MII
1
2
3