Cisco 7200 VXR - Manual (Page 12)

12
Figure 6 Installing the Rear Cable-Management Brackets with an NPE-G1 or NPE-G2 Installed—Router Front-Mounted
NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a Front-Mounted Router
If you have an NPE-G1 or NPE-G2 installed, install cable-management brackets on the rear of the router as well as on the front
of the router.
Step 1 If the back of the router protrudes from the rack, place the cable-management brackets against the router as shown in
Figure 6.
Step 2 Insert two screws into each bracket, and tighten them to the router.
Go to the “Two-Post or Four-Post Rack Installation” section on page 16.
H6423
G I G A B I T E T H E R N E T 0 / 1
R J 4 5 G B I C E N R X T X
L I N K
CONSOLE AUX
G I G A B I T E T H E R N E T 0 / 1
R J 4 5 G B I C E N R X T X
L I N K G I G A B I T E T H E R N E T 0 / 1
R J 4 5 G B I C E N R X T X
L I N K C P U R E S E T
C O M PA C T F L A S H POWER OK
S L O T A C T I V E
NETWORK PROCESSING ENGINE - G1
84399