Cisco 7200 VXR - Manual (Page 37)

37
Note If you have difficulty installing a processing engine or I/O controller in the lowest slot of a Cisco 7200 VXR
router that is rack-mounted, remove the port adapters, processing engine and I/O controller from the chassis
and reinstall them. Install the processing engine and I/O controller in the lowest slots first, then populate the
slots above them, in a bottom-to-top order.
Step 5 Grasp the handle and pull the NPE or NSE from the chassis.
Step 6 Insert the NPE or NSE and tighten the captive installation screws.
Step 7 If you are replacing an NPE-G1, install the cable-management brackets and cables. See Figure 6 and Figure 9.
Step 8 Connect the router to the power source and power up the router.
See the Network Processing Engine or Network Services Engine Installation and Configuration publication at
http://www.cisco.com/en/US/docs/routers/7200/install_and_upgrade/network_process_engine_install_config/npense.html.
Replace the I/O Controller
Figure 19 Replacing the I/O Controller
Note Before powering down the router, use the copy running-config tftp command to save the router’s running configuration
to a TFTP file server.
Step 1 Power off the router.
Step 2 Disconnect the router from the power source.
Step 3 Remove any I/O controller cables.
Step 4 On the I/O controller (1), unscrew the captive installation screws (2), grasp the handle, and pull the I/O controller from
the chassis.
1 I/O controller 2 Captive installation screws
2
ETHERNET-10BFL
EN RX
0 1 2 3 4 TX RX TX RX TX RX TX RX TX
ETHERNET 10BT
EN A B LE D
0 2
1 3 LI N K 0 1 2 3
0
4
1
3
5
6
FAST SERIAL
EN TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD
EN A B LE D
MII LINK RJ45
FAST ETHERNET
0
TOKEN RING
0 1 2 3
ENABLED IN-RING
4/16 M
bps
Cisco 7200
Series
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED PCMCIA EJECT SLOT 0
FE
ENABLEFE LINK CPU RESET 1O POWER OK
SLOT 1 FE MII
57015
1 2 2