Apple Grr - Manual (Page 8)

APPENDIX B
DIP SWITCH SEniNGS FOR YOUR PRINTER
All printers must configure to a Centronics type
parailel interface.
ANADEX 950C5-95C}1
All switches on S-3 must be off. Set switches on S-1 and ‘
S-2 appropriately.
CENTRONICS 7391
All four switches must be off.
EPSON MX-70
Shorting plug must be hooked up to the red post for no
auto-line feed.
EPSON MX-80: MX-8C5FT with Graftrax-80
All switches on S-2 should be off. Dip switch S-1, switch 8
must be on and switch 3 must be off.
(
EPSON MX-lOO
S-2 switch 3 must be off
S-1 switch 6 must be off and switch 8 must be on.
I.D.S. 440G • 445G
S-4 switches 5, 6 and 7 must be off
S-3 switches 6 must be on and switch 7 must be off
Strapping for 44(3G-445G (located beside I.D.S.
cable connector)
9-6 - busy aotive when high
10-5 - strobe data on positive edge
14-1 - always remain instalied
NEC 8023
SW-1; 6 closed, 7 closed, 8 open. All others may be set
as user desires.
SW-2: 2 open, 5 open, 6 closed, 7 closed. All orners may
be set as user desires.
MALIBU 200
Bank A Switch 2 off and aii other switches are on.
•Nole; All swilches not mentioned can be set as user desires.
GRAPPLER™ PIN ASSIGNMENTS
Function
Normal
GRAPPLER
IDS
GRAPPLER*
I.D.S. 460G • 560G OR PRISM 80 AND PRISM 132
S-4 switch 5 must be off and switch 7 on
S-3 switches 6 and 7 off
Strapping for 460G-56®G (located beside I.D.S.
cable connector)
8-7 installed for parallel
11- 4 installed for busy rising high
12- 3 installed for negative going strobe
STB 1 5
D0 3 2
D1 5 25
D2 7 23
D3 9 21
D4 11 19
D5 13 17
D6 15 4
D7 17 -
ACK 19 18
BUSY 21 12
P.E. 23 22,26
SLOT 25 7
NIC - 10,20
GND ali others all others
‘GRAPPLERs designed for use with IDS Paper Tiger printers may be
identified by a white asterisk on the upper right hand corner of the
board.
14
15
■"”WWr