Kenwood KR-897 - Manual (Page 13)

Switch ON tile power of the main unit
Select the component to be remote controlled
with one of the controlled component selection
keys.
Refer to the remote control key correspondence
table below and press the key for the desired
operation.
• Pressing the POWER key of ihe remote control unit while the STANDS Y
indicator is lit turns the power ON. Press the desired key after the
power has been turned ON.
.
•When two operation keys of the re^rnote control unit are pressed
successively, press each key securely reserving an interval of more
than t second for each press.
Remote control key correspondence table (For KENWOOD component control mode)
^Controlled component
\ selection key
□ Operation key
TUNER
CD
CD
o
TAPE1 *
CD
TAP£1
' :CD
(When used with a MD)
CD CD
P.CALL
P.CALL keys
Recalls preset stations.
l^ , ►w
(Skip key) (Skip key)
■ .
CD
AUTO
AUTO key
Press to select the auto
tuning mode.
B
(Stop key)
a
(Stop key)
B
(Stop key)
DISK SKIP
CD
A/B *100 ,
DISC SKIP key
Press to select the disc to
be played. .
A/B key
Press TAPE A or B
■»•100
► /II
CD
BAND
BAND key
Press to switch the broad­
cast band.
P/ll
(Play/pause key)
»-/II
(Forward play key)
»-/II
(Play key)
CD CD
, ►*-
(Tuning keys)
Press to tune broadcast
stations.
MM . ►►
(Search key)
M M , ►►
(Search key)
M M , ►►
(Search key)
CfD
(Reverse play key)
No remote control key is marked MD, but the
TAPE1 key can be used to control a MD player by
switching the d isplay of the main unit f torn TAPE 1
to MD. -CS j
1. The-supplied batteries are intended for use in operation checks. Therefore, their lives may be shorter than ordinary batteries.
2. When the remote-controllable distance gets shorter than before, replace both batteries with new ones.
3. Malfunction may occur if direct sunlight or the light of a high-frequency lighting fluorescent lamp enters the remote control light
sensor. In such a case, change the system installation position to prevent the malfunction.