Turn the power on, Select the speakers key setting, Select the input source – Kenwood KR-897 User Manual
Page 14: Play the selected source. adjust the volume, У ъ goo. s, O s s$13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
KR*897/KR-797 [En|
У Ъ
goo.
s ^ ^
es ss
o
s
S$13
WMTCC
------------ ,
T S 6
№
'V
Tmsr-68
t r ó
mm
0
O B M
: Kev$ Of controls to be used fn this operation
Turn the power ON.
POWER
Select the SPEAKERS key setting.
When the SPEAKERS indicator is ON;
The speakers connected to the SPEAKERS terminals on the rear
panel output sound.
When the SPEAKERS indicator is OFF:
The speakers do not output sound. Use this setting when listening
through headphones.
• For the operation when the power amplifier (KM-8971 is connected to
the KR-897, see -C£ and refer to the instruction manual of the
KM-897.
Select the input source.
■ Play the selected source.
Adjust the volume.
The input sources are switched in the following order;
®TUNER
(frequency display)
selected source is
©PHONO
^
displayed.
©TAPE1 (MD
or VIDEO!)•
©CD
©VIDEÓ2
r Tl
i.1
Switchiitg the TAPE1 display to MD or VIDEO! display
When a KENWOOD MD recorder is connected in the |SL 16] system
control mode, the TAPE 1 input should be switched to the MD input
using the following procedure.
©Select TAPE1 with the INPUT SELECTOR.
©Press and hold the AUTO key for more than 2
seconds to select MD,
^
i----------
'STAPEI
DMD
— @VIDE01
Volume level is disoleyed.
• The time taken till the volume level is displayed is variable depending
on the current operating condition.
• Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (A1 VOLUME function).
• The sound of input source cannot be listened to while TAPE 2
MONITOR is ON.