Remote control unit, Memory backup function, For the u.s.a – Kenwood KR-897 User Manual
Page 29: Fcc warning, Note, Fortheu.s.a, Note to catv system installer, For the u.s.a. fcc warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
KWB97/KB-797(En)
Remote control unit
• Baneries are exhausted. -
•The remote control unit is too far away from the
main system, controlling angle is loo large, or
there is an obstacle in between.
• The audio cords and system control cords are not
connected properly.
• The source component to be operated does not
contain the tapelsl or CD.
• An attempt is made to play a tape which is being
recorded in the cassette deck.
• Replace with new batteries.
~Q£
• Operate the remote control unit" within the
controllable range.
-QÍ
• Connect properly referring to "System con
nection",
• Race the tape(s) or CD in the source compo
nent to be played.
• Wail until the recording is cornpleted.
Memory backup function
Please note that the following items will be deleted from
this unit's memory if the power cord is disconnected
from the AC outlet or the main power switch is turned off
for approximately three days,.
• The power setting is cleared and the power is set to OFF.
• The input selection is cleared and the TUNER input is selected.
• The volume setting is cleared and'the volume is set to -80 dB.
• The receiving band setting is cleared and the FM band is selected.
• The frequency setting is cleared and 87.5 MHz is selected.
• The preset station memory is cleared.
Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for
they may deform the plastic components.
Notel
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved m the instruction manual. The user could lose the authority to operate this equipment if
an unauthorized change or modification is made.
■
NOTE:
■
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may
cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interfer
ence by one or more of ihejfgllowing measures;
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio / TV technician for help.
FortheU.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as 'close to the
point of cable entry as practical.