Remote control operation – Kenwood KC-993 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Remote
control
operation
■Programming operation
Remote control signals of other remote control units can be programmed under space keys on this unit. For space keys,
refer to "Modes" on the pretnous page.
Notes:
1. If the optical output level of the other remote control unit is higher,
programming may not be carried out correctly- If this occurs,
separate this unit and the other remote control unit by a greater
distance and perform the programming procedure again.
2. If the LEARN/TRANSMIT indicator blinks 4 times during
programming, this indicates either that the key being programmed
cannot be programmed or that programming has not been performed
completely. If this occurs, perform the programming procedure
again.
3. Remote control functions using signals other than infrared signals
or specially-coded signals cannot be programmed. Programming
is also impossible when this unit's memory capacity becomes full.
4. The LEARN indicator goes out 30 seconds after a programmable
key is pressed. After this, programming is impossible. To continue
programming, press the programming key again.
5. When two or more programmable keys are pressed at the same
time, the key which was pressed last will be programmed.
6. Do not program the remote control functions of equipment other
than A/V components, such as air conditioners, etc.
20
KC-993 (En)