In case of difficulty – Kenwood KC-993 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
In case of difficulty
What appears to be a malfunction may not always be serious. If your unit should not perform as e^qDected, consult the table
below to see if the problem can be corrected before seeking help from your dealer or service representative.
Amplifier, speakers
Symptom
Cause
Remedy
Sound is not output.
• The speaker cords are disconnected.
• The volume is set to the minimum position.
• The audio cords are disconnected.
• Connect them properly referring to
"System connections".
• Adjust the volume to a proper level.
• Connect them properly.
Sound is not output from one of the
speakers.
• The speaker cord is disconnected.
• The BALANCE control is set to an extreme
position.
m Connect it properly referring to "System
connections’.
• Adjust the Lefl/Right balance.
A hum noise is generated when the
PHONO input selector key is pressed.
• The audio cord from the turntable is not
inserted securely into the PHONO jacks.
• The turntable is not grounded.
• Insert the audio cord plugs securely into
the PHONO jacks.
• Connect the grounding wire to the GND
terminal on the rear panel.
Remote control unit
Symptom
Cause
Remedy
Remote control operation is not possible.
• Batteries are exhausted.
•
The audio cords and the system control
cords are not connected properly.
• The remote control unit is too far away from
the main system, controlling angle is too
large, or there is an obstacle in between.
• The source component to be operated does
not contain the analog disc, tape(s) or CD.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The LEARN/USE switch is set to LEARN.
• Replace with new batteries.
• Connect properly referring to "System
connections*.
• Operate the remote control unit within
the controllable range.
• Place an analog disc, tape(s) or CD in the
source component to be played.
• Wait until the recording is completed.
• Set the LEARN /USE swlteh to USE.
Notes;
1. This system is microprocessor-controlled, so malfunction may occurdue to external noise or interference noise. In such a case, unplug the power
cord, plug it and turn power on again.
2. Do not use contact cleaners because it could cause a malfunction, Be specially careful against contact cleaners containing oil. for they may
deform the plastic components.
22
KC-993 (En)