Kenwood KC-993 - Manual (Page 9)

SYSTEM CONTROL Operation
By connecting this unit to other KENWOOD system
components equipped with SYSTEM CONTROL terminals,
such as a tuner, tape deck, CD player and/or turntable, the
following convenient operations will be available.
Automatic play operation
When starting play with the turntable, tape deck, or CD player
connected to this unit, set the INPUT SELECTOR knob to PHONO,
TAPE or CD. The turntable, tape deck, or CD player will automatically
enter play mode.
In the same way, pressing the Play key of the turntable, tape deck, or
CD player will automatically switch the INPUT SELECTOR setting on
this unit to the component on which the Play key is pressed.
Synchro recording
To record the sound from the CD player or turntable onto a tape with
the tape deck, set the INPUT SELECTOR knob to CD or PHONO and
load a CD or record. Set the tape deck to record-pause mode, then
press the Play (START) key of the CD player or turntable. The deckwill
start recording automatically, synchronized with the CD player or
turntable starting playing. For more details, refer"to the instruction
manual of the tape deck,
Remote control
When the amplifier, tuner, tape deck, CD player, turntableand surround
processor (SS-992, SS-592) are connected via the system control
cords, these components can be controlled from the remote control
unit supplied with this unit.
1. System control operation of the cassette deck connected to the TAPE 2/ADAPTOR jacks cannot be carried out.
2. If the components connected to this unit are not KENWOOD system components, do not connect anything to the SYSTEM CONTROL terminals.