Kenwood DVR-6100 - Manual (Page 8)

Ш л
Maintenance
L>V 'R-6'0 d /'U V R-61UU/L
Maintenance of the Set
When the front panel, the case, etc. becomes dirty, wipe with a
soft, dry cloth. Do not use thinner, alcohol, etc., as these can
cause discoloration.
In regard to contact cleaners
Do not use contact cleaners because it could cause a malfunction.
Be specially careful not to use contact cleaners containing oil, for
they may deform the plastic component.
1
Disc handling precautions
Handling
Hold the discs so that you do not touch
the playing surface.
Sticker
Do not attach paper or tape to either
the playing side or the label side of the
discs.
Sticky paste
Cleaning
If there are fingerprint marks or foreign matter
found on the disc, lightly wipe the disc with a
soft cotton cloth (or similar) from the center of
the disc outwards in a radial manner
Storage
When a disc Is not to be played for a long period
of time, remove it from the player and store it in
its case.
Never play a cracked or warped disc
During playback, the disc rotates at high speed in the player.
Therefore, to avoid danger, never use a cracked or deformed disc
or a disc repaired with tape or adhesive agent.
Please do not use discs which are not round because they may
cause a malfunction.
Disc accessories
The disc accessories (stabilizer, protection sheet, protection ring, etc.) which are marketed for improving the sound quality or
protecting discs as well as the disc cleaner should not be used with this system because they may cause malfunction.
For the U.S.A.
CAUTION:
Use of controls or adjustments or performance of procedures other than
those specified herein may resuit in hazardous radiation exposure,
in compiiance with Federal Regulations, foilowing are reproductions of
labeis on, or inside the product relating to laser product safety.
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO
DHHS REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
Location: Back Panei
Note to CATVsysem inataller
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides guide­
lines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of
the building, as close to the point of cable entry as practical.
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy Changes or modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or
modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio
communications, if it is not installed and used in accordance with the instructions Flowever, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- - Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- - Consult the dealer or an experienced radio / TV technician for help.