Connection, Lilluwi iiftnii 'ss '.pi – Toshiba IK-542XD User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. CONNECTION
AC adapter (Sold separately)
lillUwi iiftnii 'SS '.PI
b
'
C mount lens (Sold separately)
(EXC 505G, etc.)
For pin layout of 12 pin connector, see Page 10. When
making a cable, use a connector equivalent to HIROSE
DENKI connector (HR10A-10P-12S(01)).
Important:
A matching label is provided on each camera head and controller. If heads
and controllers are mismatched performance cannot be guaranteed. Always
use units with the same matching label.
For DC power (12V), an optional AC adapter AC-M412W is recommended. When using
any other power supply, make sure it meet the following specifications:
Output voltage:
DC12V ±10%
Current capacity:
Higher than 0.4A, less than 1.0A
Ripple voltage:
Less than 50 mV (p-p)
Connector:
DC input connector
(Hirose Denki HR10A-7P-4S)
Pins 1 , 2 : © , pins 3, 4:
0
Applicable lens
When using a special mount lens (M19 pitch 0.5), the mounting threads or any protru
sion from the rear of the lens should be less than 4 mm in length. When using a C-
mount lens, the length should be less than 6.5 mm.
When the weight of the lens exceeds 300g,
Lens
mount the camera head by the lens.
This camera has no adjustment mechanisms for back focus.
1
—►
L