Installing batteries in the remote, Important battery information, Point the remote in the right direction – RCA RC5227P User Manual
Page 23: Turn on the tv and dvd player, Install batteries in the remote, Cownections &: setup
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cownections &: Setup
Installing Batteries in the Remote
1. Remove the battery compartment cover on the back of the remote.
2. Insert new batteries. Match the polarities (+ and -) on the batteries
with the diagram on the remote.
3. Put the battery compartment cover back on the remote.
Important Battery Information
•
If you’re not going to use the remote for a month or more, be sure
to remove the batteries because they can leak and cause damage.
•
Dispose of batteries in the proper manner, according to federal,
state, and local regulations.
•
Any battery may leak electrolyte if mixed with a different battery
type, if inserted incorrectly, if all batteries are not replaced at the
same time, if disposed of in fire, or if an attempt is made to charge a
battery not intended to be recharged.
•
Discard leaky batteries immediately. Leaking batteries can cause skin
burns or other personal injury.
Point the Remote in the Right Direction
when you want the remote to operate the DVD Player, point the remote
at the DVD Player, not the TV. The remote has to be pointed in the
correct direction and toward the correct component in order for the
remote’s signal to communicate with the sensor on the component.
Make sure there is a clear path between the remote and the component
you want to operate so the signal isn’t blocked.
Turn on the TV and DVD Player
1. Turn on your TV and tune to the correct video input channel (see
following page),
2, Press the DVD button on the DVD remote or the ON»OFF button on
the DVD player.
Chapter 1
21