Direct entry, Operate components after programming the remote, Other information – RCA RC5227P User Manual
Page 97: Important tips
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Information
If the component you want to control does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step until tlie device turns
back ON.
2. To finish, press and hold STOP until the red light on the remttte turn.s off.
Direct Entry
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component (jn the code list in tliis
section.
3. Point the DVD Player’s remote at the component.
4. Press and hold the component button on the remote you want to program.
5. Enter the code from the Remote Control code list on the following pages.
6. Release the component button, and then press ON*OFF to see if the component
responds to the command. If it doesn’t, try pressing the component button and then
ON*OFF again.
7. If you get no response, repeat these steps using the next code listed for your brand,
until the component responds to the remote commands.
Important Tips!
You must continue pressing
the component button while
you enter the code.
Let’s say you have a Zenith
TV. To program the universal
remote to operate the TV
you would:
Press and hold the TV button
while you enter the first
code listed for Zenith in the
TV Codes column.
Release the TV button. Press
ON-OFF to see if the TV
responds. If it
doesn't
follow
the same steps, but enter
the
second code
instead of the
first
Operate Components after Programming the
Remote
Because this universal remote can control several different components (TV, DVD, VCR,
satellite receiver, etc.) it uses operational modes triggered by the component buttons. For
example if you want the remote to control the TV, you would press the TV button to put
the remote into TV mode before you could control the TV.
1. Press the appropriate component button (DVD, TV, VCRl, VCR2, SAT*CABLE, or AUX)
to set the remote to control the component.
2. Press ON »OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Note:
This remote may not be compatible with ail brands and models of
components.
Chapter 7
95