RCA CC643 - Manual (Page 37)

The clock cell indicator ea will flash for a few seconds in the viewfinder
when you turn on the camcorder if the cell has not been installed or needs
to be replaced.
Date/Time Display — Clock Lithium Cell
Clock Cell
(+ Side
Facing Out)
Insert Object
Here to
Remove Cell
Clock Cell
Compartment
Install the Clock Lithium Cell
1. Make sure camcorder is turned off,
and remove any power supply
attached to the camcorder.
2. Press release tab of clock cell
compartment cover and open the
compartment.
3. Insert the clock cell with the “+”
terminal facing out.
4. Close the compartment cover. It will
click into place.
To Remove Lithium Cell
To remove battery, insert a pointed
nonmetallic object between battery and
compartment and lift.
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell such
as CR2025. Use of other cell presents a risk of fire or explosion. Must be
disposed of properly. Never handle punctured or leaking cell. May cause
bums or ,
Keep S^Sf Can cause death or inju^ if swallowed. If
swallowed, cons^tVphysician immediately for emergency ^atmciit.
The lithium cell used in this, device may explode resulting in a fire or chemical
bum if mistreated. Do not r^harge, disassemble, heat above 212 F (100 C), or
incinerate.^. .
Never us?metallic tweezers to hold the cell, and never short the + and - sides
of the cell. '
38