Read(x) and reset(z) report, R e a d ( x ) a n d r e s e t ( z ) r e p o r t 4, Ex.) – Toshiba MA-191 User Manual
Page 42: I a^t
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
READ(X) AND RESET(Z) REPORT
The following table shows the key operation to take each report and its
content. The "X" and "Z" reports have exactly the same content printed,
except that:
1. The "X" reports allow to read the totals but not clear memories, while
the "Z” reports allow to read the totals and at the same time all
the resettable memories will be cleared when the reports have been
issued.
2. The symbol "X" is printed on the top line of a "X" report, while "Z"
is printed on a "Z" report, to indicate the type of report.
3. A reset count is printed on the bottom of a "Z" report only.
TABLE OF X AND Z REPORTS
(REPORT NAME)
AUTO SCAN READ
AUTO SCAN RESET
(KEY OPERATION)
Mode Lock: X —
Mode Lock: Z —^
(CONTENT & REMARKS)
All DEPT & Transaction
IAT/TLI Totals that have memories
opened.
PLU AUTO SCAN READ
PLU AUTO SCAN RESET
Mode Lock: X
Mode Lock: Z
]
PLU
All
the
totals
of
PLUs
that have been set.
(The
Z
report
will
not
clear
the preset prices.)
INDIV. DEPT. READ
INDIV, PLU READ
Mode Lock: X
ex.)
IDEPT II ->
I
DEPT2
I
•»[ST]
IDEPT 3i->|DEPT4l
___ IAT/TLI
Mode Lock: X
ex) I PLU CODE|-»[PUr]
may repeat
_J
T
may
repat
IAT/TLI
Designated
Department
Item
Count, and Total (Customer
Count—optional)
(I ST I...to obtain the sub
total of the departments
printed between two
I
ST
I
key depressions.
I A^T
tl
I ... to obtain the
total of all the depart
ments printed so far and
to finalize the report.)
Designated PLU Total
( [ST] and IAT/TLI funtion
the same way as in the
INDIV.DEPT.READ operation
above.)
PLU ZONE READ
Mode Lock: X
ISTART PLU CODE
|@/FOR|
[END PLU CODE
[PLUl
Totals of the PLUs desig
nated by the zone (from the
START PLU through the END
PLU)
- 34 -