Toshiba MA-191 - Manual (Page 70)

REPLENtSHING INK
When the store message is printed too lightly, replenish the ink in the following manner.
1) Place the control lock in the LOCK position and remove the stamp cover (see Fig. 10).
2) Remove the ink roll holder (see Fig. 11).
3) Pull out the store message stamp in the direction of the arrow (see Fig. 13).
4) Apply ink to the replenishment pad at the back of the store message stamp. The amount of
refilling should be adjusted accoring to the density of the printed message, but the limit of 2 cc
should not be exceeded. (The ink bottle supplied contains 5 cc of ink), (see Fig. 14).
5) Reassembly is the reverse procedure.
SPECIFICATIONS
Size......................................... 460mtn(width) x 441 nim( depth } x 41 3niin(height)
Weight.................................................................. Approx. 23kg
AC power required.............................................. AC 117V +10% 60Hz (Varies depending on each area.)
Power consumed................................................ 60W
Size of receipt and journal tape......................... 45nitii(width) x lOOmmldiam.)
Ambient temperature.......................................... 0°- 40°C, 10 ~ 90% (Relative Humidity)
BEFORE CALLING FOR SERVICE
It is your dealer's primary concern to give full satisfaction and better service to our customers. So if any
problems arise in connection with the operation of this cash register , contact your TEC
representative listed on this papge. However, before calling for service, please check the following
points once again.
□ In case the register is inoperative with a blank display and the printer wilt not turn.
• Is the register power switch turned on?
• Is the power cord of the register connected to the wall socket properly?
• Is AC power applied to the outlet? (Plug in a lamp or light fixture to check.)
• Has the fuse blown, or has the circuit breaker been turned off?
□ In case the receipt does not come out of the receipt outlet.
• Can the red lines on the receipt or journal paper be seen?
In this case, replace the receipt of journal tape with a new roll immediately.
• The receipt paper is jammed at the receipt cutter. In this case remove the printer cover and check
the installation of the receipt paper.
YOUR TEC REPRESENTATIVE: _______________________________________________________
ADDRESS:__________________________________________________________________________________
PHONE;____________________________________________ ^................. ............... ...........................................
- 66 -