Toshiba MA-191 - Manual (Page 62)

Mode Lock: SET Key Operation:
SETTING THE LISTING CAPACITY OF DEPARTMENT
2 dig. 2^dig.
(Condition: after a Z reset)
¡2 I I@/FOR1IHALCILALC| -»1 DEPT|1HALC|LALC|^[AT/TL j
1 ----- \
(NOTE 1)(N0TE 2)
Repeat until all
-the required indiv.**
department L.C.'s
are set.
7----- T
(NOTE 1)(N0TE2)
for common L.C. for all
the departments.
NOTE 1: HALC.......High Amount Listing Capacity
'—►Number of digits
-►Value of the top digit
ex.)
[3 14j indicates 3999
--- A H 1 fj ------- -Í 4 dig. ----
-Value of the,
top digit
NOTE 2: LALC.......Low Amount Listing Capacity
ex.)
‘—►Number of digits
—►Value of the top digit
[212j indicates 29
L
2 dig.
Value of the
top digit
The amount range allowed to be entered:
equal to or smaller than the HALC,
and larger than the LALC
NOTES: 1. If the individual listing capacity of a department has
been set, it prevails over the common listing capacity
of all the departments.
2, To reset an individual department listing capacity, enter
"0" before the
I
DEPT
1
key in the above operation. Then
the common listing capacity of all the departments, if
pre-programmed, will prevail.
SETTING TENDER LISTING CAPACITIES (Condition: after a Z reset)
Mode Lock: SET Key Operation:
2 digits
iHALCt -
Refer to the
HALC descrip­
tion above.
\ AT/TLI (Cash Tender Listing Capacity)
ICHK TN^ (Check Tender Listing Capacity)
■ IChg] (Charge Tender Listing Capacity)
■ IMSC TNPl(Misc. Tender Listing Capacity)
- 58 -