RCA LCD L26HD35D - Manual (Page 38)

Connections to other equipment (continued)
To connect a HDMI or a DVI device to the unit
The HDMI 1 input receives digital audio and uncompressed video from a HDMI device or uncompressed digital
video from a DVI device.
When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate
analog audio cords required.
Rear of the unit
To DVI output
To PC/DVI
AUDIO IN
Audio cord (not supplied)
HDMI - to - DVI adapter cable
(HDMI type A connector)
.....^jJ_
DVI device
To
HDMI IN
(not supplied)
HDMI cable (type A connector)
HDMI device
To HDMI out
(not supplied)
NOTE:
• When using HDMI 1/DVI to connect your HDMI or DVI devices, you must select the corresponding
audio Input source (HDMI or DVI) on the menu screen (see “Selecting the HDMI audio Input source”
on page 25). Otherwise you will only see the Image with no sound.
• If you connect an external component (cable box, satellite receiver, etc.) to this LCD TV using an HDMI cable
or a DVI to HDMI cable, the image will not display if the output resolution of the component is set to 480I. To
receive the picture you must change the output resolution on the external component.
Should you require further instruction, please contact the manufacturer of the external component.
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including
Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with bullt-ln Dolby Digital decoder, DTS decoder, or MPEG decoder etc. as
shown below.
Rear of the unit
decoder as listed above
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio.
2 g There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.