RCA LCD L26HD35D - Manual (Page 39)

Connections to other equipment (continued)
To connect an audio system
This connection aliows you to use an audio ampiifier and external speakers, and adjust the audio ievei using the
TV’s remote control.
To control the audio, turn on the TV and the stereo ampiifier, and turn off the TV’s built-in speakers (see “Turning
off the buiit-in speakers” on page 25).
Rear of the TV
© @
To VAR (VARIABLE)
AUDIO OUT
I
a
l|^l Amplifier
1
□
o o o
D D D D D
^ O O O a
To Audio (L) Input
Audio cord (not supplied
put
T
To Audio (R) Input
NOTE:
To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set
above 0 (zero).
For example, if the volume of the TV Is set to 0, you will not be able to hear any sound, even If the volume of the
amplifier is at its highest level.
To connect the TV/DVD to a camcorder, or a TV Game
To playback from a camcorder, connect the camcorder to the unit as shown.
This unit can also be used as a display device for many video games. However, due to the wide variety of
signals generated by these devices and subsequent hook-up variations required, they have not all been
included in the suggested connection diagrams. You’ll need to consult each component’s Owner’s Manual for
additional Information.
Rear of the unit
r-AUBB-,
H Lin©!©) WDEO
@.............@ ©
t t t
m
To LINEI To VIdeo/Audio OUT
VIDEO/AUDIO IN
VIdeo/Audio cord
(not supplied)_________ I O
To connect the TV/DVD to a PC (Personal Computer)
Before you connect this TV/DVD to your PC, change the adjustment of your PC’s Resolution
and Refresh rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA
connector PC MONITOR on the rear of the TV/DVD. Attach the connectors firmly with the screws on the plug. In
case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and
to the AUDIO connector of the PC/DVI AUDIO IN jack of the TV/DVD. You can also connect the PC with HDMI
cable. If you use HDMI cable, you don’t have to connect the audio cord. If you use DVI-to-HDMI cable, please
connect audio cord as same way as VGA cable.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV/DVD can operate as the computer monitor.
Rear of the unit
pe/n*i
*■ 0
To PC
MONITOR IN
To HDM11/
DVI IN
To PC/DVI
AUDIO IN
Audio cord
(not supplied)
VGA cable
(not supplied)
NOTE:
HDMI cable (not supplied)
Monitor Display modes
MODE Resolution Refresh rate
VGA 640x480 60/ 72/ 75 Hz
VGA 720x400
SVGA 800x600
XGA 1024x768
WXGA 1280x768
WXGA 1280x720
WXGA 1360x768
To return to normal mode
Press INPUT SELECT again
70Hz
56/ 60/ 72/ 75 Hz
60/ 70/ 75 Hz
60Hz
60Hz
60Hz
The on-screen displays will have a different appearance in PC mode than in TV mode.
If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the TV-screen. 39