Comtrol UP DeviceMaster User Guide - Manual (Page 112)

112 - Chapter 5. Programming the PLC DeviceMaster UP EtherNet/IP User Guide: 2000424 Rev. L
Send Consumed Sequence Number to DeviceMaster UP
5.3.7.4. Send Consumed Sequence Number to DeviceMaster UP
Use the Configuration tab on the Message Configuration dialog to update the consumed sequence number for a
specified port on the DeviceMaster UP. Only the Write-to-Tag-Synced receive method uses this feature.
Provide the following information:
Field Selection
Message Type CIP Generic
Service Type Set Attribute Single
Service Code 10 Hex (Set Attribute Single)
Class 71 Hex (Serial Port Data Transfer object)
Instance 1 (Port 1)
Attribute 4 (Receive consumed sequence number attribute)
Source Element Com1_ConRxSeq (one INT)
Source Length
2 (one INT)