Comtrol UP DeviceMaster User Guide User Manual
Page 125
Advertising
DeviceMaster UP EtherNet/IP User Guide: 2000424 Rev. L
Chapter 5. Programming the PLC - 125
Setting up Processor and Ethernet (Channel 1)
8.
Select the Chan. 1 System tab on the Channel
Configuration dialog.
9.
Make the following recommended changes.
a.
Select the SNMP server Enable option.
(EtherNet/IP may not function without this
setting.)
b.
Select the HTTP Server Enable option.
(EtherNet/IP may not function without this
setting.)
c.
To automatically select the proper Ethernet
speed and duplex settings:
•
Select the Auto Negotiate option.
•
Select the 10/100 Mbps Full Duplex/Half
Duplex option.
10. Click OK to apply your changes and close the
Channel Configuration dialog.
Advertising