Comtrol UP DeviceMaster User Guide - Manual (Page 115)

DeviceMaster UP EtherNet/IP User Guide: 2000424 Rev. L Chapter 5. Programming the PLC - 115
Modifying an RSLogix 5000 PLC Program Example (Older Versions)
- 5.3.5. loopbackExamplePolling.L5K on Page 106
• If you still have problems loading the example .L5K file, go to the next step.
7. Make the following modifications to the .L5K file:
• Modify the ProcessorType setting in the example .L5K file to match the ProcessorType in the known
functional .L5K file (line 10 of the example .L5K file).
• Replace the MODULE local section of the example .L5K file with the Module local section in the known
functional .L5K file (lines 89 to 102).
• Choose one of the following options:
- Replace the MODULE EnetBridge section of the example .L5K file with the EtherNet/IP interface
section from the known functional .L5K file.
- Delete the MODULE EnetBridge section from the example file (lines 104 to 117).
8. Load the example .L5K file into RSLogix 5000.
• If it loads without errors, follow the appropriate process to modify the example program to run on your
system. The following topics describes how to modify the example.L5K files:
- 5.3.3. loopbackExampleTagWrite.L5K on Page 104
- 5.3.4. loopbackExampleTagWriteSynced.L5K on Page 105
- 5.3.5. loopbackExamplePolling.L5K on Page 106
• If you still have problems loading the example.L5K file, remove or modify all references to EnetBridge
in the example .L5K file and re-load the example .L5K file into RSLogix 5000.