Comtrol UP DeviceMaster User Guide User Manual
Page 124
Advertising
124 -
Chapter 5. Programming the PLC
DeviceMaster UP EtherNet/IP User Guide: 2000424 Rev. L
Setting up Processor and Ethernet (Channel 1)
5.
Double-click Processor Status, and select the
Chan 1 tab on the Data File S2 -- STATUS dialog.
6.
Make the following recommended changes.
a.
Select the DH485 Gateway Disable Bit S:34/0
option.
b.
Clear the DF1 Gateway Enable BIT S:34/5
option.
c.
Select the Comms Servicing Sel S:2/15 option.
d.
Select the Msg Servicing Sel S:33/7 option.
(You must enable this option if you want to
run EtherNet/IP.)
7.
Optionally, double-click Channel Configuration
and type a value (between 0 and 256) in the
Diagnostic File box for an integer diagnostic file. You can use the diagnostic file to help solve any network-
related problems.
Advertising