Comtrol UP 16-Port - Manual (Page 21)

DeviceMaster UP 16-Port Hardware User Guide: 2000596 Rev. B Configuring the DeviceMaster UP - 21
Configuring the DeviceMaster UP
4. Click Yes to upload the firmware.
5. Click OK to the advisory message about waiting until the DeviceMaster UP is
on-line and in the next minute the DeviceMaster UP unit or units should
display ON-LINE in the Status field.
6. Go to the DeviceMaster UP Modbus Router User Guide for information about
configuring the serial port or ports using the web page and programming your
PLCs. See
Locating Software and Documentation on Page 6 to locate the
document or refer to the installation CD shipped with the DeviceMaster UP.
If you are planning on installing multiple DeviceMaster UPs, you may want to
use the Save/Load Configuration File feature in PortVision DX.
A configuration file can contain network settings and protocol settings. Refer
to the PortVision DX help system for information about saving and loading
configuration files.
7. After configuring the serial port characteristics and preparing your PLC
programs, you can use the next section in this guide, to attach the serial device
or devices.