Comtrol UP 16-Port - Manual (Page 5)

DeviceMaster UP 16-Port Hardware User Guide: 2000596 Rev. B Getting Started - 5
Getting Started
This guide discusses initial DeviceMaster UP installation and hardware
configuration for the DeviceMaster UP with 16-ports.
This guide does not discuss configuring the port characteristics or protocol-specific
programming information. See
Locating Software and Documentation on Page 6 to
locate the firmware and the appropriate documentation for your environment.
Note: If you have a DeviceMaster UP with 1, 2, or 4-ports, use the DeviceMaster
UP Hardware Installation and Configuration Guide because the RJ45
connectors have different pin outs.
Quick Start
Installation and configuration follows these steps.
1. Connect the hardware (Page 15).
2. Install PortVision DX (Page 12).
3. Configure the DeviceMaster UP network settings (Page 16).
4. If necessary, install or update the firmware on the DeviceMaster UP for your
protocol (Page 20).
5. Use Locating Software and Documentation on Page 6 to locate the appropriate
installation document for your protocol so that you can perform the following
procedures:
• Configure port characteristics using the Server Configuration web page.
• Program the PLCs.
6. Connect the serial device or devices (Page 91).