Cisco WEC600N - Manual (Page 17)

Chapter 3
Configuration
16 Dual-Band Wireless-N ExpressCard
Wi-Fi Protected Setup
If you connect to a router that supports Wi-Fi Protected
Setup, then you will view this screen:
Select a Method
Before you begin, make sure the router and the computer
with the Adapter are in the same room. Then select the
method that is most convenient for you.
Push Button (Recommended) Select this option to use
the push button method.
Use Adapter’s PIN number Select this option to enter
the Adapter’s PIN number on the router.
Enter Key Manually Select this option to manually enter
the security key.
Click Next to continue, or click Back to return to the
previous screen.
Proceed to the instructions for the method you selected.
Use the Push Button
Press the 1. Wi-Fi Protected Setup button on the router.
Within two minutes, click the 2. Wi-Fi Protected Setup
button on this screen.
Use the Push Button
The Adapter connects to the network. 3.
Connecting to the Network
Click 4. Print to print out your wireless network settings.
Then click Finish to return to the Status screen, or click
Exit to exit the Monitor.
Congratulations
Congratulations! The Adapter is connected to
the network.
Enter the Adapter’s PIN Number
Access the web-based utility of the router. (Refer to the 1.
router’s documentation for instructions.)
On the router’s
2. Wi-Fi Protected Setup screen, enter
the Adapter’s PIN number in the PIN field. Then click
Register.