Digilent 410-044-10P-KIT - Manual (Page 37)

Spartan-3 Starter Kit Board User Guide www.xilinx.com 37
UG130 (v1.1) May 13, 2005 1-800-255-7778
Program Push Button/DONE Indicator LED R
Program Push Button/DONE Indicator LED
The Spartan-3 Starter Kit Board includes two FPGA configuration functions, located near
the VGA connector and the AC power input connector, as shown in
Figure 9-1 . The PROG
push button, shown as in Figure 9-1 , drives the FPGA’s PROG_B programming pin.
When pressed, the PROG push button forces the FPGA to reconfigure and reload it
configuration data.
The DONE LED, shown as in Figure 9-1 , connects to the FPGA’s DONE pin and lights
up when the FPGA is successfully configured.
Slave Parallel
<0:1:1>
Another device connected to the B1 expansion connector
provides parallel data and clock to load the FPGA.
JTAG
<1:0:1>
The FPGA waits for configuration via the four-wire JTAG
interface.
Table 9-1: Header J8 Controls the FPGA Configuration Mode (Continued)
Configuration
Mode
<M0:M1:M2>
Header J8
Settings
Jumper JP1
Setting
Description
MODE
M0 M1 M2
J8
GND JP1
MODE
M0 M1 M2
J8
GND JP1
Figure 9-1: The PROG Button and the DONE LED
17
18
PROG
DONE
VG
A
VGA
UG130_c9_03_042704
17
18