Digilent 410-044-10P-KIT - Manual (Page 45)

Spartan-3 Starter Kit Board User Guide www.xilinx.com 45
UG130 (v1.1) May 13, 2005 1-800-255-7778
R
Chapter 12
Power Distribution
AC Wall Adapter
The Spartan-3 Starter Kit includes an international-ready AC wall adapter that produces a
+5V DC output. Connect the AC wall adapter to the barrel connector along the left edge of
the board, indicated as
in Figure 1-2 . There is no power switch to the board. To
disconnect power, remove the AC adapter from the wall or disconnect the barrel connector.
The POWER indicator LED, shown as in Figure 1-2 , lights up when power is properly
applied to the board. If the jumpers in the J8 header and JP1 header are properly set and
there is a valid configuration data file in the Platform Flash memory, then the DONE
indicator LED, shown as
in Figure 1-2 , also lights up.
The AC wall adapter is directly compatible for North America, Japan, and Taiwan locales.
Other locations might require a socket adapter to convert from the North American
standard to the local power socket standard. The AC wall adapter operates from 100V to
240V AC input, at 50 or 60 Hz.
Voltage Regulators
There are multiple voltages supplied on the Spartan-3 Starter Kit Board, as summarized in
Table 12-1 .
Overall, the 5V DC switching power adapter that connects to AC wall power powers the
board. A 3.3V regulator, powered by the 5V DC supply, provides power to the inputs of the
25
26
18
Table 12-1: Voltage Supplies and Sources
Voltage Source Supplies
+5V DC AC Wall Adapter, 5V switching power supply
(
in Figure 1-2 )
3.3V regulator
Optionally, PS/2 port via jumper JP2 setting
Pin 1 (VU) on A1, A2, B1 expansion connectors
+3.3V DC National Semiconductor LM1086CS-ADJ 3.3V
regulator (
in Figure 1-2 )
2.5V and 1.2V regulators
V
CCO
supply input for all FPGA I/O banks
Most components on the board
Pin 3 on A1, A2, B1 expansion connectors
+2.5V DC STMicroelectronics LF25CDT 2.5V regulator
(
in Figure 1-2 )
V
CCAUX
supply input to FPGA
+1.2V DC Fairchild Semiconductor FAN1112 1.2V
regulator (
in Figure 1-2 )
V
CCINT
supply input to FPGA
25
27
28
29