Ecler CA200z - Manual (Page 16)

16
zones). In STEREO, MONO and BRIDGE (single zone) modes, the detailed adjustments are
shared, given that there are no zones for independently directing and adjusting the audio sources.
The following graphic shows the ADVANCED adjusting procedure for the MIC1 and
MIC2 inputs (a special key combination is required for access):
VOL
Rotate knob
to adjust
level
Front knob SP: Short Press (press the front panel knob briefly, less than 0.5 seconds)
Front knob LP: Long Press (press & hold the front panel knob for more than 2.5 seconds)
MICx VOLUME
Level: 0 to 64
LP to enter
the VOLUME
adjust mode
LP
BASS
TREBLE
Front panel MIC sources setup
Level
shown in
LCD
To enter the MIC SETUP MODE, first select zone A or B with a tap of the front knob or
the IR remote (only when using the ZONES mode), then press MIC1 or MIC2 key and
hold it for more than 2.5 seconds
Press & hold MICx key
to enter MICx setup mode
MICx setup mode
(x = 1, 2, 3 or 4)
Default mode (STEREO / MONO / BRIDGE / ZONE A or ZONE B)
SP to get
back
Rotate knob
to browse
options
SP to get
back
Level
shown in
LCD
LP
LP to enter
the BASS
adjust mode
MICx BASS
Level: -10 to +10
Rotate knob
to adjust
level
Rotate knob
to browse
options
Rotate knob
to adjust
level
MICx TREBLE
Level: -10 to +10
LP to enter
the TREBLE
adjust mode
LP
Level
shown in
LCD
Rotate knob
to browse
options
MIC1 or MIC2
LP
Press and hold MIC1 + MIC2 +
front panel knob to enter the
MIC SETUP ADVANCED MODE
Rotate knob
to browse
options
ADVANCED MODE
KEY CODE REQUIRED
MIC1 MIC2
+ +
SP to get
back
SP
SP
SP
SP